To change the IP address on the Sensor and reboot the Sensor using the command-line interface (CLI), follow the steps below:

1. Log on to the Sensor CLI. 
2. Type deinstall and press Enter.
    
3. Set the new IP address. Type set sensor IP x.x.x.x y.y.y.y and then press Enter.
   
   NOTE: Replace x.x.x.x with the needed IP address for the Sensor and y.y.y.y with the needed subnet mask. 
    
4. Reboot the Sensor.
   Type reboot and press Enter.
    
5. After the Sensor reboots, log on to the CLI of the Sensor again and re-establish trust with the manager.
   Type set sensor sharedsecretkey and press Enter.
    
6. Type the sharedsecretkey and press Enter.
7. Type Status and press Enter to verify the status of trust establishment.
   Trust Established status means that the trust establishment process has completed.